我們知道電纜橋架都會呈現哪些毛病嗎?下面就跟大家分享一下電纜橋架使用過程中出現的常見問題吧！

Do we know what problems cable trays will exhibit? Let's share with you the common problems that arise during the use of cable trays!

一、可能呈現的毛病：電纜的各部分都呈現短路表象，這類毛病可能會形成配電柜上的電流繼電器作業，對電纜形成的損壞十分嚴峻;

1、 Possible problems: All parts of the cable show signs of short circuits, which may cause current relay operation on the distribution cabinet and cause severe damage to the cable;

二、會呈現的毛病：電纜內部呈現短路，這類毛病通常是因為電纜質量低質而形成的，外表上不會流露痕跡;

2、 Problems that may occur: There is a short circuit inside the cable, which is usually caused by the low quality of the cable and does not show any traces on the surface;

三、可能會呈現整條電纜被燒斷或許某處電纜被燒斷，使得電纜在毛病處損壞的十分嚴峻;

3、 It is possible that the entire cable may be burnt out, or a cable may be burnt out in a certain area, causing severe damage to the cable at the faulty location;

四、可能會呈現的毛病為電纜橋架只有一條短路，毛病處電纜損壞較輕，但還是會有很明顯的痕跡。這類毛病可能會呈現的原因在于電流太大或許電纜質量太差而形成的。

4、 The possible problem is that there is only one short circuit in the cable tray, and the cable damage at the fault is relatively minor, but there will still be obvious traces. The possible reasons for such problems may be due to excessive current or poor cable quality.

機械設備使用后都要定期進行檢查、保養。

Mechanical equipment should be regularly inspected and maintained after use.

1 、電纜橋架設備平衡氣缸動作狀況及其機油潤滑系統油路,接頭等測試檢查.

1. Test and inspect the operation status of the balance cylinder of cable tray equipment, as well as the oil circuit and joints of the oil lubrication system

2 、電纜橋架設備滑塊與導軌之間的摩擦較為頻繁，應做必要的調整較正，檢查接頭部位的潤滑優良及管路等，保證良好的運轉。

2. The friction between the sliding block and the guide rail of the cable tray equipment is relatively frequent, and necessary adjustments should be made to ensure proper alignment. The lubrication of the joint parts and pipelines should be checked to ensure good operation.

3 、定期為電纜橋架設備齒輪部位潤滑：齒輪傳動箱及內部機件因為經常運轉損壞的可能性比較大，出現松動的可能性更大。

3. Regularly lubricate the gear parts of cable tray equipment: The possibility of damage to the gear transmission box and internal components due to frequent operation is higher, and the possibility of looseness is greater.