電氣橋架安裝是比較嚴格的，很對人對內部能不能出現電線接頭存在爭議，那橋架里可以有電線接頭嗎?跟著濟南電纜橋架廠家一起來了解看看吧。

The installation of the electrical bridge is relatively strict. There is a dispute about whether there can be wire connectors inside the bridge. Can there be wire connectors in the bridge? Follow Jinan cable tray manufacturer to learn about it.

正確情況下是不允許有電線接頭的，因為電線接頭是整個線路的薄弱點所在，非常容易出現問題，若是設置在橋架里的話，出現問題基本上就無法進行維修，這樣會導致整個電路不能使用，也會影響到用電安全。

It is not allowed to have wire joints under the correct conditions, because the wire joints are the weak points of the whole line, which is very easy to cause problems. If they are set in the cable tray, the problems will be basically impossible to repair, which will lead to the entire circuit can not be used, and will also affect the safety of electricity.

當然，在實際施工中難免會遇到需要在橋架里接線的情況，這時候就要求非常好的接頭工藝，才能避免問題出現的更多可能性。對于橋架中有設置電線，建議是配置線槽和導管，將電路保護在內，更不容易出現問題。

Of course, in the actual construction, it is inevitable to meet the need to wire in the cable tray. At this time, a very good joint process is required to avoid more possibilities of problems. For the cable tray with wires, it is recommended to configure trunking and conduit to protect the circuit, which is less likely to cause problems.

電纜橋架施工一定要規劃好電路走線，要根據建筑本身布局等進行布線，同時要考慮后期維修問題，參考各方面的因素，選擇橋架的佳線路。可以從建筑墻、柱、梁或者樓板等就近架設，施工更方便，而且能減少管架、立柱的使用。

During the construction of cable tray, the circuit routing must be well planned, and the wiring should be carried out according to the layout of the building itself. At the same time, the problems of later maintenance should be considered, and the best route of cable tray should be selected by referring to various factors. It can be erected nearby from the building walls, columns, beams or floors, which is more convenient for construction and can reduce the use of pipe racks and columns.

電纜橋架的荷載是有限的，若是超出范圍的話，很容易出現不穩定、掉落等情況，因此要對主干線上面的縱斷面電纜重量進行計算，控制在荷載范圍內，這樣才能保證使用安全。

The load of the cable tray is limited. If it is out of range, instability, falling and other situations are likely to occur. Therefore, the weight of the vertical cable above the trunk line should be calculated and controlled within the load range to ensure safe use.

電纜橋架的設置是很關鍵的，它的寬度決定了電纜排布間距、型號安全性等等，也關系到托臂的長度、支柱的長度，因此橋架的寬度一定要控制到位。

The setting of cable tray is very important. Its width determines the cable layout spacing, model safety, etc., and also relates to the length of corbel and pillar. Therefore, the width of cable tray must be controlled in place.

看到這里相信大家對橋架里可以有電線接頭嗎已經有所了解了吧，如果您想要了解更多相關知識，可以關注我們網站http://www.ymmgjx.net！

After seeing this, I believe that you have already understood whether there can be wire connectors in the cable tray. If you want to know more about this, you can follow our website http://www.ymmgjx.net ！